Ferrari enthusiasts refer to the options by various names, 'Daytona package' being the most popular. 'Sebring spyders' and 'Chairs and flares' are also used in the USA. The British refer to them as Dinos with 'big arches'.

'Daytona seats'

Even though it is common to find Daytona seats in cars with wide fender flares and wide wheels mentioned above, it was a separate option and had to be ordered in addition to the flares and wide wheels. The owner of Dino 04878 claims to have a letter from the Ferrari factory which states that his car was the first to be equipped with daytona seats by the factory. Earlier cars are known to have them, but it is possible that owners have switched seats or had them redone with daytona inserts.

The factory invoices described them as:
'Daytona type central seat panels'

Versions-246 Dinos

246 Dinos were built in three distinct versions.

1. European versions, or home market cars, were left hand drive cars identified by the front signal lamps which laid flat and blended with the front contour of the coachwork. Clear white lenses were normally fitted. Small round amber signal lamps were also found on the sides of the front fenders. Chassis number was visible from outside the car on a small stamped metal plate fixed inside the windscreen on the pillar near the drivers vent window. Most times, over the years, these plates have been removed or lost. Some later European cars had chassis number stamped on the steering column like the USA versions described below.

2. British versions were identical to the European versions except they had right hand steering controls and were fitted with amber color front signal lenses. Other markets may also have used the amber lenses. After S/N 04830 chassis number stamped on steering column as in USA models described below.

3. USA versions are most easily identified by the front signal lamps which were recessed into the bodywork and their amber lenses stood vertically. In addition to anti pollution equipment fitted to the engine of these cars, rectangular side marker lamps were fitted on the sides at the four corners, the front ones replacing the small round lamp used on European and British versions. Two reflectors were added at the rear of the car on either side of the number plate area. Chassis number is stamped on the steering column and is visible from outside the car through the windscreen.

Version production totals

European version 1900 cars (estimated)
Known British versions 246GT -498 cars
Known British versions 246GTS-242 cars
Total British GT & GTS 740 cars
USA version 1275 cars (estimated)
_____________________________________________________________________________
246 Types,(Series) Totals
Type 'L',(Series I) 357 cars (all coupes)
type 'M',(Series II) 507 cars (all coupes)
type 'E',(Series III) 2897 cars*
*(1623 coupes, 1274 spyders)
Coachwork variations
1. Early cars - Type 'L'(Series I) from 00400 up to car no. 01116.
a. Lockable trunk button on rear lid.
b. Door opening lights not fitted like the later cars.
c. Outside door locks located in recessed air scoop portion
of the door.
d. Deep passenger foot well. Folding foot rest observed on

Dino And Aliens Free Download

many examples, but not shown in owners handbook.
e. Heater/defroster controls located on center console near
the gear lever. Long glove box door.
f. Seat back adjustment control in addition to fore & aft
control levers.
g. Two back-up lamps fitted; one under each rear bumper bar.
h. Head rests mounted on the bulkhead behind the seats.
i. Doors did not have parcel boxes like the later cars.
j. Passenger assist grip mounted on door sill next
to the passenger seat.
Later cars - Type 'M' and 'E'(Series II & III from 01118 through 08518)
a. Rear lid release moved inside the car with the fuel filler
cover and engine release levers. An emergency pull ring
was now located behind fuel filler cap lid for the rear lid.
b. Door opening lights fitted in the inside edge of the doors.
c. Outside door locks located below the recessed air scoop
portion of the door.
d. Shallow passenger footwell.
e. Heater/defroster controls located in center of dashboard.
Short glove box door.
f. Seats had only fore & aft adjustment.
g. Only one back-up lamp mounted directly on the coachwork
and located at the bottom of the rear panel in the center.
h. Head rests mounted on the seats.
i. Parcel boxes fitted to each of the inside door panels.
3. Some cars - Constructed with alloy doors, engine lid, and trunk lid.
(Usually type 'L')
Two known 246 Dinos in the 005xx range have full alloy bodies.
Some cars - Constructed with only alloy doors and maybe only front lid.
(Usually type 'M')
Aliens
later cars - Constructed in all steel, except an alloy front lid.
(Probably all type 'E')
4. Early cars - Two rear number plate lamps located in each of the rear
(from 01118) bumper ends. Exact change point unknown. European versions
kept this system until sometime between 04554 and 04648.
British versions changed earlier-sometime between 02808
and 03354. USA versions apparently never used this layout,
and used the one described below.
Dino And Aliens Serial Number
Later cars - One rear number plate lamp was mounted on rear lid, and
recessed bumper end caps were fitted where the two
lamps were previously. European and British versions
used this system throughout the entire production range.
USA versions used the recessed caps from about 02800
up to about 04370 when they changed as described below.
Later cars - USA versions replaced the recessed rear bumper end caps
with a flat cap around car number 04370. Exact change
point is unknown.
5. Early cars - Type 'E' (Series III)
European and British version changed from long front
bumpers to short ones. Exact change point unknown.
1st known car on file with short front bumpers is S/N 04428.
This page last updated September 15, 2001
Back to Dino Register
HOME!
Added to site2006-01-21
Rating94/100
Votes69

To see serial numbers, please prove you are not a robot.

Dino And Aliens Serial Number Decoder

Content protected by qrlock.me service.

How it works.

Dinos And Aliens Game

  1. Use your mobile phone (smartphone) to scan the QR code that you see here.
  2. In the opened window (on the smartphone), select the pin code that you see (----).
  3. Press (on the smartphone) button with this pin code
  4. Wait a few seconds, everything else will happen automatically.
  5. If this does not happen, refresh the page and try again. Otherwise - contact the technical support of the site.
More details ...
You need to scan the QR code shown on the site using your mobile phone (or tablet) and perform the required actions on your device.
In order to be able to scan the code, use the camera of your phone. For Apple phones, no additional software is required (just point the camera at the QR code and follow the instructions). Most Android-based phones also do not require third-party programs.
For those who have problems, we recommend a program for reading QR codes Privacy Friendly QR Scanner (we are not affiliated with this software, but tested this application and it performs the necessary functions).
You can download it from google play.

dinoandaliensv1.1crackcphv.zip (727249 bytes)

namesizecompressed
Dino.and.Aliens.v1.1.Cracked.WinAll-CPHV/CPHV.nfo69692364
Dino.and.Aliens.v1.1.Cracked.WinAll-CPHV/Crack/DinoAndAliens.exe743424724092
Dino.and.Aliens.v1.1.Cracked.WinAll-CPHV/file_id.diz324179

Dino.and.Aliens.v1.1.Cracked.WinAll-CPHV/CPHV.nfo


Dino.and.Aliens.v1.1.Cracked.WinAll-CPHV/file_id.diz